Instruction manual

vARIABLE NAME MNEMONIC FACTORy SETTINGS CUSTOMER SETTINGS
Program Menu
Output
Output
– ___________
4 mA 4 mA 0 µS ___________
20 mA 20 mA 20 mS ___________
Hold hold 21 mA ___________
Fault fault 22 mA ___________
d ampening dpn 0 samples/second ___________
Test test 04.00 mA ___________
Temperature
temp
Auto temperature compensation tauto on ___________
Manual temperature tman 25.0°C (overridden by auto) ___________
Temperature compensation algorithm COMP (Linear or n salt LinEAr ___________
or Cation or nOnE)
Display
display
Measurement type typ (ConduC or ConduC ___________
rstvty or Cust)
Temperature (°C or °F) temp C ___________
o utput (mA or %) output Cur ___________
Security Code code 000 ___________
Custom Curve
SEtUP
CuSt ___________
Reference temperature t ref 25.0°C ___________
Calibrate Menu
Cell constant CELL Const 1.00 ___________
Temperature slope tEMP slOpe 2.000 ___________
o utput Calibration OUtPUt CAL ___________
Diagnose Menu
Diagnose SAMPLE READINGS
(Each segment displays the current value in the transmitter.)
Absolute conductivity Abs 1000 µS ___________
o ff Set 0 Air 0.0 µS ___________
Cell constant (Linear mode) CELL COnSt 1.000 ___________
Temperature slope tslope 2.000 ___________
Calibration factor CAL F 1.000 ___________
Software version soft A02.18 ___________
Hardware version HArd 01 ___________
Show fault warnings FaULTS none ___________
TABLE 5-2. Default Settings for Model 5081-C-HT
38
MODEL 5081-C SECTION 5.0
DISPLAy AND OPERATION