Instruction manual

MODEL 5081-C SECTION 1.0

DESCRIPTION AND SPECIFICATIONS

1.7 FOUNDATION FIELDBUS

Figure 1-4 shows a 5081-C-FF being used to measure conductivity. The figure also shows three ways in which Fieldbus

communication can be used to read process variables and configure the transmitter.

FIGURE 1-4. CONFIGURING MODEL 5081-C TRANSMITTER w ITH FOUNDATION FIELDBUS

1.8 GENERAL SPECIFICATIONS

Model: 5081-C-FF Fieldbus Transmitter

Type: Contacting Conductivity Transmitter

Device ITK Profile: 6 (Released for iTK 6.0.0 / 6.0.1)

Manufacturer Identification (MANUFAC_ID): 0x524149

Device Type (DEv _TyPE): 0x4084

Device Revision (DEv_REv): 0x03

Linkmaster: Yes

Number of Link Objects: 20

vCR’s supported: 20

Mandatory Features:

• Resource Block

• Alarm and Events

• Function Block Linking

• Trending

• Multi-Bit Alert Reporting

• Field d iagnostics

Additional Features:

• Common Software d ownload

• Block instantiation

• Supports d eltaV Auto Commissioning

• Supports d eltaV Auto Replacement

• Supports d eltaV Firmware Live d ownload

• PlantWeb Alerts with re-annunciation / multibit

• Supports Easy Configuration Assistant

Function Blocks (Execution Time):

• 4 – Analog input Blocks (15 mseconds)

• Ai Block Channels:

Channel 1: Conductivity, Resistivity, Concentration

Channel 2: Temperature

Channel 3: Raw Conductivity

• Proportional integral d erivative (25 mseconds)

Power:

• Two Wire d evice; Fieldbus Polarity insensitive

• Current d raw: 21 mA

• d evice Certifications: iS / FiSCo

• Maximum certified input Voltage for iS: 30V

• Maximum certified input current for iS: 300mA

• Maximum certified input power for iS: 1.3W

• internal Capacitance (Ci): 0 nF

• internal inductance (Li): 0 μH