Instruction manual

69
MODEL XMT-P pH/ORP SECTION 7.0
PROGRAMMING THE TRANSMITTER
SECTION 7.0
PROGRAMMING THE TRANSMITTER
7.1 GENERAL
This section describes how to program the transmitter using the keypad.
1. Configure and assign values to the 4-20 mA output (-HT version only).
2. Test and trim the current output (-HT version only).
3. Select the measurement to be made (pH, ORP, or Redox).
4. Choose temperature units and automatic or manual temperature mode.
5. Set a security code.
6. Make certain settings relating to HART communication (-HT version only).
7. Program the transmitter for maximum reduction of environmental noise.
8. Resetting factory default settings.
9. Selecting a default display screen and adjusting screen contrast.
7.2 CHANGING START-UP SETTINGS
When the Solu Comp Xmt is powered up for the first time, startup screens appear. The screens prompt the
user to enter the measurement being made, to identify the sensor being used, to select automatic or manual
pH correction and to select temperature units. If incorrect settings were entered at startup, enter the correct
settings now. To change the measurement, refer to Section 7.4.