Instruction manual

56
MODEL XMT-P pH/ORP SECTION 6.0
OPERATION WITH MODEL 375
Temp mode [Live, Manual] (1)
Man temp (6)
Temp unit [ºC, ºF]
Temp snsr [RTD PT100, RTD PT1000, Manual]
Signal condition
LRV
URV
AO Damp
% rnge
Xfer fnctn
AO1 lo end point
AO1 hi end pt
Output condition
Analog output
AO1
AO Alrm typ
AO hold val
Fault mode [Fixed, Live]
AO fault val
Loop test
D/A trim
HART output
PV is [pH, ORP/Redox]
SV is [pH (1), ORP/Redox (2), Temperature, Input , GlassZ (1), RefZ, RTD Ohms, Uncorr pH (1)]
TV is [pH (1), ORP/Redox (2), Temperature, Input , GlassZ (1), RefZ, RTD Ohms, Uncorr pH (1)]
4V is [pH (1), ORP/Redox (2), Temperature, Input , GlassZ (1), RefZ, RTD Ohms, Uncorr pH (1)]
Poll addr
Burst option [PV, %range/current, Process vars/crnt, Process vars]
Burst mode [Off, On]
Num req preams
Num resp preams
Device information
Distributor
Model
Dev id
Tag
Date
Physical signl code
Write protect
Snsr text
Descriptor
Message
Revision #'s
Universal rev
Fld dev rev
Software rev
Hardware rev
Diagnostics
Diagnostics [Off, On]
GFH (1)
GWH (1)
GWL (1)
GFL (1)
Ref imp [Low, High]
RFH
RWH
0 limit
Local Display
AO LOI units [mA, %]
LOI cfg code
LOI cal code
Noise rejection
Load Default Conf.
Review
PV
PV AO
PV LRV
PV URV
FIGURE 6-2. XMT-P-HT HART/Model 375 Menu Tree (2 of 2)
Notes:
(1) Valid only when PV is pH
(2) Valid only when PV is ORP/Redox
(3) Valid only when PV is pH and solution temperature
correction is custom
(4) Valid only when PV is pH and solution temperature
correction is not off
(5) Valid only when Fault mode is Fixed
(6) Valid only when PV is pH and temp mode is manual.