Instruction manual

ManualsBrandsEmerson ManualsConsumer electronicsSolu Comp Xmt-P-FF/FI

MODEL XMT-P pH/ORP SECTION 5.0

DISPLAY AND OPERATION

1. If a security code has been programmed, pressing MENU causes the

security screen to appear.

2. Enter the three-digit security code.

a. If a security code has been assigned to configure only, entering it will

unlock all the menus.

b. If separate security codes have been assigned to calibrate and con-

figure, entering the calibrate code will allow the user access to only

the calibrate and hold menus; entering the configuration code will

allow the user access to all menus.

3. If the entered code is correct, the main menu screen appears. If the code

is incorrect, the Invalid Code screen appears. The Enter Security Code

screen reappears after two seconds.

Enter Security

Code: 000

Invalid Code

Calibrate Hold

Program Display

Hold Outputs?

Yes No

5.6 SECURITY

5.6.1 How the Security Code Works

Use security codes to prevent accidental or unwanted changes to program settings, displays, and calibration. Two

three-digit security codes can be used to do the following…

a. Allow a user to view the default display and information screens only.

b. Allow a user access to the calibration and hold menus only.

c. Allow a user access to all the menus.

5.6.2 Bypassing the Security Code

Enter 555. The main menu will open.

5.6.3 Setting a Security Code

See Section 7.6.

5.7 USING HOLD

5.7.1 Purpose

The transmitter output is always proportional to the process variable (oxygen, free chlorine, total chlorine, mono-

chloramine, or ozone). To prevent improper operation of control systems or dosing pumps, place the transmitter in

hold before removing the sensor for maintenance. Be sure to remove the transmitter from hold once the work is

complete and the sensor has been returned to the process liquid. During hold the transmitter current goes to the

value programmed by the user. Once in hold, the transmitter remains there indefinitely. While in hold, the word

"hold" appears periodically in the display.

5.7.2 Using the Hold Function

1. Press MENU. The main menu screen appears. Choose Hold.

2. The Hold Output screen appears. Choose Yes to put the transmitter in

hold.

3. The top line in the display is the present current output. Use the arrow

keys to change the number in the second line to the desired current dur-

ing hold.

4. The main display screen appears.

5. To take the transmitter out of hole, repeat steps 1 and 2 and choose No

in step 2.

Output Range? 10.00mA

Hold at 20.00mA