Instruction manual

ManualsBrandsEmerson ManualsConsumer electronicsSolu Comp Xmt-P-FF/FI

MODEL XMT-C SECTION 9.0

PROGRAMMING THE TRANSMITTER

9.3.3 Procedure: Configuring the Output

1. Press MENU. The menu screen appears. Choose Program.

2. Choose Output.

3. Choose Configure.

4. Choose Fault.

5. Choose Fixed or Live.

6. If you chose Fixed, the screen at left appears. Use the arrow keys to

change the fault current to the desired value. The limits are 4.00 to 22.00

mA. If you chose Live, there are no settings to make.

7. The screen at left appears. Choose mA/%.

8. Choose mA or percent. Percent means the display will show percent of

full scale reading.

9. The screen at left appears. Choose Damping.

10. Use the arrow keys to change the blinking display to the desired time con-

stant.

1. From the main display, press MENU. The menu screen appears. Choose

Program.

2. Choose Output.

3. Choose Range.

4. Assign a value to the 4 mA output and press ENTER. Then assign a value

to the 20 mA output. Press ENTER. Use the arrow keys to change the

flashing display to the desired value.

Calibrate Hold

PPrrooggrraamm

Display

Display Ouput?

mmAA

percent

OOuuttppuutt

Temp

Measurement >>

Configure?

FFaauulltt

mA/% Damping

Configure? Fault

mmAA//%%

Damping

Configure? Fault

mA/%

DDaammppiinngg

Set to value?

FFiixxeedd

Live

Current Output

if Fault:

2.00mA

Damping? 000 255

00 sec

Output range?

4mA

.000μS/cm

Output? Test

CCoonnffiigguurree

Range