Instruction manual

MODEL XMT-C SECTION 9.0

PROGRAMMING THE TRANSMITTER

SECTION 9.0

PROGRAMMING THE TRANSMITTER

9.1 GENERAL

This section describes how to program the transmitter using the keypad.

1. Configure and assign values to the 4-20 mA output [-HT version only] (Section 9.3)

2. Test and trim the current output [-HT version only] (Section 9.3)

3. Select the measurement to be made [conductivity, resistivity, or TDS] (Section 9.4)

4. Choose temperature units and automatic or manual temperature mode (Section 9.5)

5. Set a security code (Section 9.6)

6. Resetting factory default settings (Section 9.8)

7. Selecting a default display screen and adjusting screen constrast (Section 9.9)

9.2 CHANGING START-UP SETTINGS

When the Solu Comp Xmt is powered up for the first time, startup screens appear. The screens prompt the

user to enter the measurement being made, to enter the cell constant, and to select temperature units. If incor-

rect settings were entered at startup, enter the correct settings now. To change the measurement, refer to

Section 9.4.