Installation manual

30
Reference Manual
00809-0100-4075, Rev CA
Section 4: Commissioning
March 2014
Commissioning
4.2 Device network configuration
In order to communicate with the Smart Wireless Gateway, and ultimately the Information
System, the transmitter must be configured to communicate with the wireless network. This
step is the wireless equivalent of connecting wires from a transmitter to the information system.
Using a Field Communicator or AMS, enter the Network ID and Join Key so that they match the
Network ID and Join Key of the gateway and other devices in the network. If the Network ID
and Join Key are not identical, the THUM Adapter will not communicate with the network. The
Network ID and Join Key may be obtained from the Smart Wireless Gateway on the Setup>Net-
work>Settings page on the web server, shown in Figure 4-1.
Figure 4-1. Gateway network setting
AMS
Right click on the THUM Adapter and select Configure. When the menu opens, select Join
Device to Network and follow the method to enter the Network ID and Join Key.
Field communicator
The Network ID and Join Key may be changed in the wireless device by using the following Fast
Key sequence. Set both Network ID and Join Key.
Operation can be verified in three locations: by using the Field Communicator, at the Gateway
via the Smart Wireless Gateway’s integrated web server, or via AMS
™
Wireless Configurator.
Function Key sequence Menu items
Wireless Setup 1,4 Smart Power, Network ID, Set Join Key, Radio State