Installation guide

Installation Guide AMS Suite: Intelligent Device Manager
NOVEMBER 2013
99
• In the Connection dialog, select the communications port of the PC to which
you are going to attach the STAHL Network. If necessary, adjust the Baud Rate
and Device timeout value. Refer to AMS Device Manager Books Online for
details. Click Next.
• In the Advanced dialog, adjust the RS-485 scan address range. To optimize
performance, set the address range to include only the addresses where
systems are located.
• To verify the baud rate or other information, select the STAHL Network name in
the Network Configuration dialog and click Properties. If necessary, change the
information shown on the three tabs.
• Changes will take effect when AMS Device Manager is restarted.
NOTICE
Do not configure two HART primary masters (such as AMS Device Manager and a
control system)–this is an invalid setting and can produce unpredictable results.