Installation guide

Installation Guide AMS Suite: Intelligent Device Manager
NOVEMBER 2013
95
Configuring AMS Device Manager for a PROVOX
Interface
To configure AMS Device Manager for a PROVOX network interface:
1. Select Start > All Programs > AMS Device Manager > Network Configuration
from the Windows taskbar.
2. In the Network Configuration dialog, click Add.
3. In the Select Network Component Type dialog, select PROVOX Network and
click Install.
4. Follow the PROVOX Network Wizard instructions.
5. Start AMS Device Manager to set up the network structure. See “Determining
the system interface structure and device data” on page 108.
RS3
A Rosemount System 3 (RS3) system controls field devices linked together through
Controller cards connected to a PeerWay through ControlFiles. A PeerWay can
accommodate up to 32 system devices, called nodes, to allow each control system
device to communicate through the PeerWay and the RS3 Network Interface (RNI).
Preparing the RS3 system
To prepare an RS3 control system to communicate with AMS Device Manager, you
must:
• Know the TCP/IP address and DNS name of your RNI. If you do not know these,
see your system administrator.
• Set up a username and password for the system interface on your RNI (see
“Verifying communication with the RNI” on page 97).
• Verify that the RNI responds.
Setting RNI username and password
To set up a username and password for the system interface on your RNI:
1. On your RNI, open the RNI user configuration file,
\\RNIBOOT\CONFIG\USERFILE.CFG. You can open it with the Notepad utility, or
any other text editor.