Installation guide

Installation Guide AMS Suite: Intelligent Device Manager

NOVEMBER 2013

7. In the Connection Properties dialog, select the Ovation System Parameters you

will be using.

• FOUNDATION fieldbus device support

• FOUNDATION fieldbus device alert support

• PROFIBUS DP device support

• WirelessHART device support

If you select WirelessHART device support, you must also identify the Smart

Wireless Gateway name and IP address, as well as enable secure

communications with the Wireless Gateway if you have installed the Security

Setup utility for the Smart Wireless Gateway.

8. The data fields in the Timings dialog contain default values which you cannot

change. Click Help for more information about the fields on this dialog.

9. Click Finish to complete the Ovation Network interface setup.

10. Click Close.

11. Start AMS Device Manager to set up the network structure. See “Determining

the system interface structure and device data” on page 108.

Note

Do not configure an AMS Device Manager Wireless System Interface if an Ovation System

Interface will be using the same wireless gateway.

Note

You must have computer administrator privileges to install an Ovation network.

Note

If you install both the Ovation System Interface and the FF HSE Interface on the same PC,

you must configure each on a unique IP address.

NOTICE

If an Ovation System Interface is removed and later re-added, any PROFIBUS DP

devices will need to be reidentified. To avoid this, back up your database before

removing the Ovation System Interface. After re-adding the interface, import the

backed up database.