Installation guide

AMS Suite: Intelligent Device Manager Installation Guide
NOVEMBER 2013
88
7. Enter the DeltaVAdmin password and password confirmation, if it has been
changed from the default.
8. Select the options to enable HART, FOUNDATION fieldbus, WirelessHART and
PROFIBUS DP device support, as needed.
9. Click Next.
10. On the Advanced tab, enter a high address for the PROVOX I/O Scan Range if
your DeltaV system uses a PROVOX migration controller.
11. Click Finish to save the configuration.
12. Click Close.
13. Start AMS Device Manager to set up the network structure. See “Determining
the system interface structure and device data” on page 108.
If you have multiple DeltaV Zones or networks which include additional Server Plus
Stations, the Server Plus Connect utility lets you access those other Server Plus
Stations from a Client SC Station. For more information, refer to AMS Device Manager
Books Online.
To install AMS Device Manager on a DeltaV network, refer to “Installing AMS Device
Manager 12.5 on DeltaV stations” on page 68.
Note
The DeltaVAdmin password is an administrative password given to each DeltaV system.
The same password must be used to access all DeltaV networks configured on this station.
If no password is entered, a connection will be attempted using the default DeltaV
password.