Installation guide

AMS Suite: Intelligent Device Manager Installation Guide
NOVEMBER 2013
86
5. Click Yes.
6. Click Close.
7. Start AMS Device Manager. See “Determining the system interface structure
and device data” on page 108.
DeltaV
A DeltaV control network is an isolated Ethernet local area network (LAN) that
provides communication between the controllers and the stations. It uses one or
more Ethernet hubs for communication.
For information about AMS Device Manager compatibility with DeltaV, refer to
page 30.
DeltaV can access devices in RS3 and PROVOX I/O systems through the DeltaV
Interface for RS3 I/O and DeltaV Interface for PROVOX I/O, respectively. The devices
are displayed in the DeltaV network hierarchy in AMS Device Manager. For more
information, refer to the DeltaV Books Online and documentation.
To receive alerts from devices connected to PROVOX and RS3 Migration Controllers in
your DeltaV network hierarchy, you must run a utility to properly set the DeltaV alert
capability.
To run the utility:
1. Select Start > Run from the Windows taskbar.
2. In the text box, type C:\AMS\BIN\DELTAVFASTSCANUTILITY.EXE (where C is the
drive containing the AMS folder).
3. Uncheck the box for the appropriate DeltaV network.
4. Click Save Changes.
The AMS ValveLink SNAP-ON application is supported for DeltaV and PROVOX I/O
cards, but not for RS3 I/O cards.
Note
Do not configure an AMS Device Manager Wireless System Interface if a DeltaV System
Interface will be using the same wireless gateway.