Installation guide

AMS Suite: Intelligent Device Manager Installation Guide

NOVEMBER 2013

Figure 1. Device Wiring Diagram

A To PC COMM port connection

BHART modem

C 250 ohm resistor

D 24vDC power source

ETransmitter

F Optional ground connection

After a modem is installed

AMS Device Manager continuously polls the modem connection and automatically

recognizes a device once the device and modem are installed.

AMS Device Manager shows the installed device connected to the modem after you

have completed the procedure on

page 74. If you do not see the device, do the

following:

• Check your connections again.

• Make sure the modem is properly installed.