Installation guide

AMS Suite: Intelligent Device Manager Installation Guide
NOVEMBER 2013
54
Installing Client SC Station software
The following steps install the Client SC Station software.
Verifying Client SC Station connectivity
Use the ping command to verify that the designated Client SC Station PC responds to
communications sent to it by the Server Plus Station:
1. At the AMS Device Manager Server Plus Station, select Start > Run from the
Windows taskbar.
2. In the text box, type CMD and click OK to open a command prompt.
3. At the command prompt, type PING <Client SC Station Computer Name>.
4. Press ENTER.
5. Verify that the Client SC Station PC responds to the ping command.
The ping command should return a reply message. If the ping command fails,
verify that you typed the correct PC name in the command line. Also verify that
your network is functioning properly. Contact your IT department if you cannot
establish connectivity.
To install software on a Client SC Station:
1. Clear all applications from the Windows Startup folder until after installation is
finished. Exit/close all Windows programs including any running in the
background (such as virus scan software).
2. Insert the AMS Device Manager program DVD in the DVD drive of the PC to be
used as a Client SC Station.
3. When the AMS Device Manager setup starts, click Install AMS Device Manager.
4. Click Client SC Station.
5. Follow the prompts.
Note
If the autorun function is disabled on your PC, double-click
D:\AMSDEVICEMANAGER_SETUP.EXE (where D is the DVD drive letter) and click OK.
NOTICE
Do not interrupt the installation process, otherwise the software will not be fully
installed and will malfunction. The installation process includes some system
restarts. Do not remove the program DVD until the installation is complete.