Installation guide

AMS Suite: Intelligent Device Manager Installation Guide
NOVEMBER 2013
40
HART Over PROFIBUS
The HART Over PROFIBUS System Interface requires that:
• AMS Device Manager is installed on a PC running a supported operating
system.
• A control system that supports PROFIBUS DP V1 is configured and operational.
• At least one Trebing & Himstedt (T+H) PROFIBUS Gateway for communications
is configured and the current version of the T+H AMS Device Manager
Communications Components (TACC) software is installed.
• At least one PROFIBUS DP remote I/O subsystem that supports HART
communications is connected to the control system. Contact your Emerson
Process Management Sales/Service Office for a list of supported I/O
subsystems.
• At least one HART I/O module is installed in the remote I/O subsystem. See the
Release Notes for a list of supported HART I/O modules.
• At least one HART instrument is present on a module channel.
Refer to the TH AMS Device Manager Communication Components HART Over PROFIBUS
User Guide downloaded from T+H for more information.
Kongsberg
The Kongsberg System Interface requires that:
• The version of the Kongsberg Control System is AIM v8.3.
• The Kongsberg System is set up and the Automation Server is accessible from
the AMS Device Manager station.
• The URL for the Kongsberg Automation Server is known.
• One or more Remote Control Units (RCUs) are available on the Kongsberg
Network where PROFIBUS Masters or HART Masters may be configured.
— PROFIBUS Masters allow the connection of HART DP Slave and I/O
Modules, which connect HART instruments to the network.
— HART Masters allow the connection of HART Multiplexers, which connect
HART instruments to the network.
Note
Prior to moving to AMS Device Manager 12.5 from previous versions supporting HART
Over PROFIBUS, contact your Emerson Process Management Sales/Service Office to ensure
your system is fully supported. Additional testing may be required.