Installation guide

AMS Suite: Intelligent Device Manager Installation Guide
NOVEMBER 2013
32
• Supported PROFIBUS DP I/O hardware and software revision:
— PROFIBUS Series 2+, Revision 1.36 or higher
— PROFIBUS S-Series, Revision 1.36 or higher
• Supported Wireless I/O:
— Wireless I/O card (WIOC), Revision 11.3.1 or higher
— Smart Wireless Gateway, Revision 3.95 or higher
• Security–The DeltaV password (if not using the default password) must be
entered in the AMS Device Manager Network Configuration utility (see
“Configuring AMS Device Manager for a DeltaV System Interface” on page 87).
DeltaV supports:
• FOUNDATION fieldbus devices
• Wired HART Rev. 5, Rev. 6, and Rev. 7 devices
• WirelessHART Rev. 7 devices
• PROFIBUS DP devices
• PROFIBUS PA devices (supported on DeltaV 11.3 or higher with an S-Series
PROFIBUS DP I/O card and a PROFIBUS DP/PA Coupler on a PROFIBUS DP
segment. See Release Notes for supported couplers.)
• HART safety devices connected to DeltaV Safety Instrumented System (SIS)
logic solvers
• HART safety devices connected to DeltaV 12.3 (SIS) CHARMs logic solvers
DeltaV versions 9.3.1 and later can access devices connected to RS3 and PROVOX I/O
systems through the DeltaV Interface for RS3 I/O and DeltaV Interface for PROVOX I/
O, respectively. The devices are displayed in the DeltaV network hierarchy in AMS
Device Manager. For installation and setup information, refer to the DeltaV Books
Online.
To receive alerts from devices connected to PROVOX and RS3 Migration Controllers in
your DeltaV network hierarchy, you must run a utility to properly set the DeltaV alert
capability.


Note
Some HART Rev. 6 and Rev. 7 commands are not supported by the DeltaV system.
Although AMS Device Manager recognizes additional revisions of HART devices when using
other HART communication devices, it will not recognize them when they are connected to
DeltaV.