Installation guide

AMS Suite: Intelligent Device Manager Installation Guide
NOVEMBER 2013
30
DeltaV
DeltaV System Interface station software requirements:
• AMS Device Manager 12.5 can be installed on the following DeltaV 9.3.1,
10.3.1, 11.3, 11.3.1, 12.3 stations:
• The DeltaV System Interface must be configured on a licensed AMS Device
Manager station that is on the DeltaV network.
To install AMS Device Manager on a DeltaV network, see the procedures in “Installing
AMS Device Manager 12.5 on DeltaV stations” on page 68.
• For HART support only, AMS Device Manager 12.5 can be installed on a
separate PC connected to a DeltaV 9.3.1 or 10.3.1 ProfessionalPLUS Station
through a separate Ethernet connection. Contact your local Emerson Process
Management Sales/Service Office for more information.
• AMS Device Manager 12.5 supports DeltaV version 11.3 and later in co-
deployed installations only.
• If the Server Plus software is not on a DeltaV station, the SI and Simulate
dongles cannot be used to license AMS Device Manager — a license.dat file is
required.
DeltaV Workstations AMS Device Manager Software
ProfessionalPLUS Station Server Plus or Client SC
ProfessionalPLUS as Remote Client Server Server Plus or Client SC
Local Application Station Server Plus or Client SC
Remote Application Station Server Plus or Client SC
Local "Operate" Station
• Professional
• Operator
• Base
• Maintenance
Server Plus or Client SC
Operator Station as Remote Client Server Client SC only
Remote "Operate" Station
• Professional
• Operator
• Base
Client SC only