Technical data

Controls, LEDs, and Connectors
COMX-CAR-610 COM Express Carrier Board Installation and Use (6806800K26D)
40
You need to set a 3-pin jumper (P10) if you want to configure USB multiplexed devices.
3.4.5.2 USB 3.0
5USB_P 6NC
7GND 8GND
9NC 10Key
Table 3-19 P10, Jumper Settings for Configuring USB Multiplexed Devices
Jumper Setting Configuration
P10 (1-2) USB 2.0 onboard
P10 (2-3) Mini Card (Default)
Table 3-18 P39, USB 2.0 Header Pin Definition (continued)
Pin Signal Pin Signal
Table 3-20 J14 and J15, USB 3.0 Connector Pin Definition
Pin Signal Pin Signal
15V 2 USB_P0 _N
3USB_P0 _P 4 GND
5 USB0_SSRX _N 6 USB0_SSRX _P
7GND 8 USB0_SSTX _N
9 USB0_SSTX _P 10 5V
11 USB_P1 _N 12 USB_P1 _P
13 GND 14 USB1_SSRX_N
15 USB1_SSRX _P 16 GND
17 USB1_SSTX _N 18 USB1_SSTX _P