Technical data

Hardware Preparation and Installation

COMX-CAR-610 COM Express Carrier Board Installation and Use (6806800K26D)

2. Check for damage and report any damage or differences to customer service.

3. Remove the desiccant bag shipped together with the product.

2.3 Installation and Removal of the COM Express

Module

The assembled COM Express module with the attached heat spreader is attached to a carrier

board.

Installing the COM Express Module on the Carrier Board

1. Line up the board-to-board connector of the COM Express module with the board-

to-board connector of the COMX-CAR-610.

2. Make sure that the interconnectors are properly aligned and that the seven

standoffs have contact with the top of the COMX-CAR-610.

3. Turn over the COM Express module and the COMX-CAR-610.

4. From the backside of the COMX-CAR-610, locate the screw holes.

5. Use the screws to fasten the COM Express module assembly to the COMX-CAR-

610.

Environmental Damage

 Improper disposal of used products may harm the environment.

 Always dispose of used products according to your country’s legislation and

manufacturer’s instructions.