User's Manual

Communication
43 SOLA HD
®
S5KC
™
3.6 MultiLink
®
MultiLink monitors the UPS continuously and can shut down configured computers in the event of an
extended power failure. MultiLink can also be configured to shut down the UPS. MultiLink can also
be configured for use without the USB cable when the IntelliSlot
®
UNITY-DP SNMP Card is installed
in the UPS. An optional MultiLink License Kit permits shutting down the UPS over a network. For
more information about the IntelliSlot SNMP Card, IntelliSlot Web Card and MultiLink license kits,
visit http://www.solahd.com or contact your local Emerson representative.
3.7 LCD Port
The LCD module contains the LCD port, which is used for power and data communication between
the UPS monitor module and display module. The LCD module can be removed from the SolaHD
S5KC and remotely located. A longer Ethernet cable must be used when installing the LCD module
remotely. A standard Ethernet (Category 5, with RJ-45 connectors, both ends meet T568B standard)
type cable can be used. Maximum cable length is 14 meters to ensure proper communication signals
between the UPS and the LCD module.
The user interface module provides three network ports and one USB port. Of those, one network port
(LCD port) is used for power supply and communication of the user interface module. Other network
ports and the USB port are reserved for use only by customer service personnel.
Figure 50 LCD port
LCD Port
User Interface
Module