User's Manual

Installation
25 SOLA HD
®
S5KC
™
3. Use a #2 Phillips screwdriver to install the screws into the holes on each end.
4. Slide the lever toward the right, as shown in Figure 30.
Figure 30 Lever and fastener on System Control and System Monitor Module
5. Replace the LCD module and display bezel.
2.5 Cable Connection
Refer to the unit model number in Table 2 to determine which instructions to use for installation.
!
WARNING
Risk of electric shock. Can cause injury or death.
Disconnect local and remote power supplies before working within.
Read this section thoroughly before attempting to install wiring to this unit.
Ensure that all the UPS input sources are disconnected off before attempting to install wiring
to this unit.
This UPS cables should be connected by a properly trained and qualified electrician.
Table 2 Cable connection method reference
UPS Model #
Digits 1-4
Frame Type
Manual
Section
S5KCA 10 Bay Transformer-free 2.5.1
S5KCB 16 Bay Transformer-free 2.5.1
S5KCC 12 Bay Transformer-based 2.5.2
S5KCD 16 Bay Transformer-based 2.5.2
S5KCE 10 Bay Transformer-free 2.5.3
S5KCF 16 Bay Transformer-free 2.5.3
Mounting
Hole
Lever
Mounting
Hole
Pull
Out
Before Pressing
Lever
After Pressing
Lever
Press and Slide
to the Right