User's Manual
Installation
SOLA HD
®
S5KC
™
24
2.4.2 Installing System Control and System Monitor Modules
NOTICE
Risk of unintended shutdown. Can cause equipment damage.
Do not remove both the control and the monitor modules at the same time. Removing both the
control module and monitor module at the same time will cause the UPS to shut down and
remove power from the load. Replace these modules one at a time.
1. Remove the display bezel and the user interface (LCD) module on top of the frame, as shown in
Figure 28.
Figure 28 Remove large display bezel and user interface module
2. Push the module slowly until about 1cm of the module is still out of the bay, and then press it
firmly to ensure that the module is fully inserted, as shown in Figure 29.
Figure 29 Insert the System Control and System Monitor module
Large Display Bezel
User Interface Module