Specifications

Heated Flame Ionization Detector Analyzer Module
Rosemount Analytical NGA 2000
748414-A
August 1999
51
MAINTENANCE AND TROUBLESHOOTING
4
4.2.9.1 R
EPLACING
F
RONT
P
ANEL
C
OMPONENTS
1. To access components, remove the four front panel mounting screws (two on front, one
on each side).
2. Remove the burner air regulator and fuel regulator mounting nuts.
3. Remove the purge air regulator mounting bracket screws.
The front panel can now be pulled away from the chassis.
NOTE
The wiring from front panel components is still connected. Do not disconnect unless
replacing that component.
F
IGURE
4-21. A
CCESSING
F
RONT
P
ANEL
C
OMPONENTS
Front panel mounting screw
(opposite side also)
Front panel
mounting screws