Instruction manual

NGA 2000 MLT Hardware
OPENING OF HOUSING
15 - 3
Emerson Process Management GmbH & Co. OHG
Instruction Manual
90002929
07/2006
15.1.1.2 Front Panel
Removing of front panel can be done without removing of housing covers:
❍ Disconnect module from power supply.
❍ Remove analyzer module out of platform (Item 17.1 of platform manual).
❍ Unscrew the 6 fastening screws at both housing sides (Fig. 15-2)
or
unscrew the 4 fastening screws at front panel (Fig. 15-2).
❍ Remove front panel to the front carefully.
Optionally internal components may be fixed to the front panel, e.g. inter-
nal fan, UVS, oxygen sensor, pressure sensor (see fig. 1-7)!
Repeat above steps in reverse order to assemble the housing
Take care not to squeeze internal electrical connections and gas lines when
assembling the housing!
Fig. 15-2: MLT 1 (Plattform housing)
(Fastening screws front panel)
MLT 1 (PLATFORM HOUSING)
Fastening screw,
front housing cover
Fastening screws,
module front panel
Fastening screws,
module front panel
ME -+
Network
CAUTION !
Use either
front
rear
supply
OR