Instruction manual

NGA 2000 MLT Hardware
INSTALLATION
5 - 9
Emerson Process Management GmbH & Co. OHG
Instruction Manual
90002929
07/2006
5.4 Analyzer Specific Instructions
5.4.1 MLT 1
5.4.1.1 MLT 1, platform mounting only
MLT 1 analyzer module housing is available for platform mounting (built-in into a NGA platform)
only (type M).
These analyzers need DC 24 V power supply and netwotk connection utilizing platform. Built-in
the modul into platform housing correctly (see platform manual).
Switching On the module will be done via Switching On the platform.
Output signals and data are accessible at the rear panel via submin-d connectors. Depending on
analzyer variation not all signals are available. For information about pin-assignments see section
21.
ANALYZER SPECIFIC INSTRUCTIONS: MLT 1
Fig. 5-3: MLT 1 analysis module (platform mounting), front panel, front view
ME
-+
Network
CAUTION !
Use either
front
rear
supply
OR
Network
24 V dc
IN