Instruction manual
Table Of Contents
- INSTRUCTION MANUAL HFID
- ESSENTIAL INSTRUCTIONS
- TABLE OF CONTENTS
- PREFACE
- DEFINITIONS
- SAFETY INSTRUCTIONS WIRING AND INSTALLATION OF THIS APPARATUS
- OPERATING AND MAINTAINING THIS APPARATUS
- GENERAL SAFETY NOTICE / RESIDUAL RISK
- AUTHORIZED PERSONNEL
- GASES AND GAS CONDITIONING (SAMPLE HANDLING)
- POWER SUPPLY
- ELECTROSTATIC DISCHARGE
- GENERAL PRECAUTIONS FOR HANDLING AND STORINGHIGH PRESSURE GAS CYLINDERS
- DOCUMENTATION
- COMPLIANCES
- GLOSSARY OF TERMS
- ANALYZER SYSTEM ARCHITECTURE
- SECTION 1: DESCRIPTION AND SPECIFICATIONS
- SECTION 2: INSTALLATION
- SECTION 3: OPERATION
- SECTION 4: MAINTENANCE AND SERVICE
- SECTION 5: TROUBLESHOOTING
- SECTION 6: REPLACEMENT PARTS
- RETURN OF MATERIAL
- LIST OF FIGURES AND TABLES
- SUPPLEMENT
Instruction Manual
HAS64E-IM-HW
September 2008
NGA 2000 HFID
4 - 25Maintenance and ServiceEmerson Process Management GmbH & Co.OHG
4-12 REAR PANEL COMPONENTS
The following components are mounted to the rear panel:
• Fuel In 2-Way Solenoid Valve
• Regulated Air In Check Valve
Figure 4-22: Rear Panel Components
• Burner Air In Filter
• Heated Sample Bypass Out Restrictor
• Heated Sample In Restrictor
Check Valve,
Regulated Air IN
903728
Solenoid Valve,
Fuel IN
656218
Filter,
Burner Air IN
017154
Restrictor,
Bypass OUT
10 Micron
619615
Restrictor,
Heated Sample IN
40 Micron
619616
VIEW FROM OUTSIDE ANALYZER MODULE
VIEW FROM INSIDE ANALYZER MODULE