Instruction manual
Table Of Contents
- INSTRUCTION MANUAL HFID
- ESSENTIAL INSTRUCTIONS
- TABLE OF CONTENTS
- PREFACE
- DEFINITIONS
- SAFETY INSTRUCTIONS WIRING AND INSTALLATION OF THIS APPARATUS
- OPERATING AND MAINTAINING THIS APPARATUS
- GENERAL SAFETY NOTICE / RESIDUAL RISK
- AUTHORIZED PERSONNEL
- GASES AND GAS CONDITIONING (SAMPLE HANDLING)
- POWER SUPPLY
- ELECTROSTATIC DISCHARGE
- GENERAL PRECAUTIONS FOR HANDLING AND STORINGHIGH PRESSURE GAS CYLINDERS
- DOCUMENTATION
- COMPLIANCES
- GLOSSARY OF TERMS
- ANALYZER SYSTEM ARCHITECTURE
- SECTION 1: DESCRIPTION AND SPECIFICATIONS
- SECTION 2: INSTALLATION
- SECTION 3: OPERATION
- SECTION 4: MAINTENANCE AND SERVICE
- SECTION 5: TROUBLESHOOTING
- SECTION 6: REPLACEMENT PARTS
- RETURN OF MATERIAL
- LIST OF FIGURES AND TABLES
- SUPPLEMENT
Instruction Manual
HAS64E-IM-HW
September 2008
NGA 2000 HFID
P - 9PrefaceEmerson Process Management GmbH & Co.OHG
POWER SUPPLY
ELECTRICAL HAZARD
Verify the power voltage at site of installation corresponds to the analyzer
module´s rated voltage as given on the nameplate label!
Verify the safety instruction given by power supply unit manufacturer !
CAUTION
ELECTRICAL HAZARD
The mains socket has to be nearby the power supply unit and easily accessible!
Disconnecting from power requires unplugging the power connector!
To comply with the CE mark requirements use only power supply units of type
SL5, SL10 or equivalent units. Equivalent units must provide SELV output
voltages!
Verify proper polarity when connecting DC 24 V operated analyzer modules !
CAUTION