Instruction manual
Table Of Contents
- INSTRUCTION MANUAL HFID
- ESSENTIAL INSTRUCTIONS
- TABLE OF CONTENTS
- PREFACE
- DEFINITIONS
- SAFETY INSTRUCTIONS WIRING AND INSTALLATION OF THIS APPARATUS
- OPERATING AND MAINTAINING THIS APPARATUS
- GENERAL SAFETY NOTICE / RESIDUAL RISK
- AUTHORIZED PERSONNEL
- GASES AND GAS CONDITIONING (SAMPLE HANDLING)
- POWER SUPPLY
- ELECTROSTATIC DISCHARGE
- GENERAL PRECAUTIONS FOR HANDLING AND STORINGHIGH PRESSURE GAS CYLINDERS
- DOCUMENTATION
- COMPLIANCES
- GLOSSARY OF TERMS
- ANALYZER SYSTEM ARCHITECTURE
- SECTION 1: DESCRIPTION AND SPECIFICATIONS
- SECTION 2: INSTALLATION
- SECTION 3: OPERATION
- SECTION 4: MAINTENANCE AND SERVICE
- SECTION 5: TROUBLESHOOTING
- SECTION 6: REPLACEMENT PARTS
- RETURN OF MATERIAL
- LIST OF FIGURES AND TABLES
- SUPPLEMENT
Instruction Manual
HAS64E-IM-HW
September 2008
NGA 2000 HFID
P - 3PrefaceEmerson Process Management GmbH & Co.OHG
OPERATING AND MAINTAINING THIS APPARATUS
On leaving our factory, this instrument conformed to all applicable safety directives.
In order to preserve this state of affairs, the operator must take care to strictly follow all the instructions and
notes given in this manual and on the unit.
Before switching on the instrument, ensure that the local nominal mains voltage corresponds to the factory-set
operational voltage of this unit.
Any interruption of the protective earth connections, whether inside or outside of the unit, or removal or inter-
ruption of its ground line connection, may result in exposure to the risk of electricity. Deliberately disconnected
the protective earth is therefore strictly forbidden.
Removing covers and opening panels may expose components conducting electric current. Connectors may
also be energized. The unit therefore should be be disconnected from all electrical supplies before any kinds
of maintenance, repair or calibration work requiring access to the inside of the unit. Only trained personnel who
are aware of the risk involved may work on an open and energized unit!
Fuses may only be replaced by fuses of an identical type and with identical ratings. It is forbidden to use
repaired fuses or to bypass fuses.
Take note of all applicable regulations when using this unit with an autotransformer or a variable transformer.
Substances hazardous to health may escape from the unit‘s gas outlet.
Please pay attention to the safety of your operation personnel. Protective measures must be taken, if required.
NOTE
Software compatibility is necessary for all NGA 2000 components in your system to work together.
The version of your Platform’s software must be equal to or greater than the version of any other
module(s) for successful compatibility.
You can locate the version of each NGA 2000 component as follows:
Platform Controller Board
Turn power ON. The display should show „Control Module V3. ...“. This is the software version.
Analyzer Module
See note on the name plate label located on the right side of the Analyzer Module case.