Specifications

S
TARTUP AND
O
PERATION
748410-A
August 1999
15
Chemiluminescense Detector Analyzer Module
Rosemount Analytical NGA 2000
3
After the warm-up period (about one hour for the CLD Analyzer Module), all modules are
completely functional. Establish that correct ozonator air pressure and sample flow rate are
within specifications (see the Specifications page in the Preface section of this manual).
Calibrate and adjust converter efficiency, and begin routine operation as the following
sections indicate.
3.4 B
INDING
To achieve full coordination between Analyzer Modules and associated I/O Modules, the
user must bind those components together in the System Set Up portion of the Technical
Configuration Menu in software.
F
IGURE
3-1. R
UN
M
ODE
D
ISPLAY
F
IGURE
3-2. M
AIN
M
ENU
D
ISPLAY
Analyzer PQ 322-14
23.2 ppm NO
0
pp
m
50
Secondar
y
Variable: XXXX
Secondar
y
Variable: XXX
Secondar
y
Variable: XXXX
Secondar
y
Variable: XXXX
Display Parms. Menu Dual Info
F1
F2 F3 F4 F5
23.2 ppm NO Analyzer XXXXXXXX
Main Menu
Expert controls and setup ...
(Operational configuration)
Technical level configuration ...
(Diagnostic and manufacturing/service)
Display Parms. Info
F1
F2 F3 F4 F5
Basic Controls
Delete alarm message!