User manual

Accessing an RPC2 Communications Module via the Web Interface
29 Emerson
®
RPC2
™
4.8.2 System Tab—Devices
Click Devices in the System tab navigation tree to view a read-only page about the MPH2 rack PDU
and the RPC2 communications module. Available information includes the System Name (user-
specified), system location, system description, contact personnel names, MPH2 manufacturer, the
RPC2 serial number and firmware label and the MPH2 model, serial number and firmware version.
Click the Print icon at the top of the page to print the summary table.
4.8.3 System Tab—Device Change
Click Device Change in the System tab navigation tree to to view device changes, such as a Rack
PDU Array
™
being added or removed, a rack PDU being added to an array, sensors being added or
removed or a module added to a Liebert MPX. This page displays module serial number and type and
shows when modules were added and removed. Click the Acknowledge icon to acknowledge changes
and remove them from the page.
NOTE
A large white X on a red background is displayed in the upper left corner when a device change
has not been acknowledged by the user. This will occur at initial startup, when the RPC2
communications module is installed for the first time, when a sensor is added or removed and
in similar instances. After an event or change has been acknowledged, the event may take a few
seconds to clear and the X should change to a white checkmark (✔) on a green background.
An X is also displayed if alarms are present.