User manual

Accessing an RPC2 Communications Module via the Web Interface
25 Emerson
®
RPC2
™
The Measurements tab displays the receptacle’s current, voltage, real power, apparent power, power
factor, energy and crest factor information. The Status tab displays whether the receptacle is within
acceptable limits for overcurrent and low current thresholds. The Information tab displays general
information about the receptacle. The Settings tab permits editing settings on a receptacle.
To edit a receptacle:
1. Log in with the privileges required to change these settings.
2. From the PDU Explorer tab, click the rack PDU with the branch containing the receptacle to be
edited.
3. Click the branch with the receptacle to be edited.
4. Highlight the receptacle to be edited by clicking on it.
5. In the table at the bottom of the page, click the Settings tab.
6. Check the box or boxes next to the settings to be edited.
7. Click the Edit icon .
8. Enter the new values or use the drop-down menu to enable or disable software overcurrent
protection or change whether the receptacle is designated critical.
9. When finished, click the Save icon, ✔, to make the change or click the Cancel icon to discard
the change.
X