User manual

Accessing an RPC2 Communications Module via the Web Interface

Emerson

RPC2

™

To edit sensor information:

1. Put a checkmark, ✔, in the box to the left of the portion to be changed.

2. Click the Edit icon

• If assigning a label: Enter the new label (the default is the sensor’s serial number).

• If changing the Asset (sensor in this case): Enter a new name for the sensor (default names are

Tag01 and Tag02.

•If changing the Alarm Config, click on the drop-down menu and choose Alarm when close,

Alarm when open or None.

3. Click the Save icon,✔, to save the change or click the Cancel icon to discard the change.

Figure 17 Change a sensor value

4.3.5 PDU Explorer Tabs: Information

The PDU Explorer’s Settings tab displays information about the MPH2 as shown in Figure 18. The

information on the tab is read-only.

Figure 18 PDU Explorer tabs: Information

Put a check

mark in the box

for the value to

be changed

Choose a setting from

the drop-down menu