User manual

Accessing an RPC2 Communications Module via the Web Interface
17 Emerson
®
RPC2
™
4.3 PDU Explorer Tab
The PDU Explorer displays data from connected equipment, starting with the rack PDU view at the
highest level, allowing users to browse down one level to view branches, then another to view the
receptacles. It also permits viewing sensors and editing sensor settings.
Figure 12 PDU Explorer main page
The PDU Explorer main page shows available information about the MPH2 on the lower tabs:
Measurement (shown at the main page), Status, Settings and Information.
The Measurements tab displays the rack PDU’s current, voltage, power, energy and frequency
information. The Status tab displays whether the rack PDU is within acceptable limits for
overcurrent, low current and low voltage thresholds. The Information tab displays general
information about the rack PDU. Settings on the rack PDU can be edited under the Settings tab.
MPH2 rack PDU
being viewed;
clicking this
hyperlink will
display the
branch level
Clicking on a
branch will
show data for
that branch
Data shown at
rack PDU level