User manual

Installation
7 Emerson
®
RPC2
™
2.4 User Level Privileges
The RPC2 communications module permits four user levels:
• Administrator—can configure and control all rack PDU’s in the system
• Power User—can configure rack PDU’s; no receptacle control
• Appliance—can view rack PDU’s; no configuration or control
• User—can view rack PDU’s specified by administrator; no receptacle control
Because of the varying authorization levels, the user interface’s appearance will be different for each
level of user. For details on user levels, see 4.8.7 - Authorization Levels.
Access to the RPC2 communications module requires entering a password. The default administrator
level user name and password is admin. Each is case-sensitive. Emerson Network Power recommends
changing the password immediately to prevent unauthorized access to MPH2 rack PDU’s.
2.4.1 Group Membership and Access
Adding a user to a default group automatically sets the user’s access. For example, adding a user to
the Appliance group permits that user to view rack PDU’s to determine the units’ status, but
Appliance group users cannot configure or control a rack PDU.
2.4.2 Change Administrator’s Password
1. Open a Web browser and enter the IP address of the RPC2 communications module.
2. Log in with the default username admin and the default password admin.
3. Click on the System tab > Authorization > Change Password
4. Enter the new user name.
5. Enter the new password.
6. Confirm the new password.
7. Click on the Save icon, ✔, at the top of the screen to make the change or click the Cancel icon
to discard the change.
X
Save Icon Cancel Icon