user manual

ManualsBrandsEmerson ManualsNetwork RouterNetwork Router PMT1

Monitor: Start-up Display

PmT1 and PmE1 User’s Manual 10002367-02

8-4

START-UP DISPLAY

At power-up or after a reset, the monitor runs diagnostics and reports the results in the

start-up display. The PmT1 and PmE1 displays have identical diagnostic reports.

Figure 8-1: Monitor Start-up Display

Note: The results of the power-up diagnostic tests are displayed at power-up or after a reset. A failed memory test

could indicate a hardware malfunction that should be reported to our Technical Support department at

http://www.emersonembeddedcomputing.com/contact/postsalessupport.htm on the internet or send e-

mail to support@artesyncp.com.

At power-up and reset, the monitor configures the board according to the contents of non-

volatile configuration memory. If the configuration indicates that an autoboot device has

been selected, the monitor attempts to load an application program from the specified

device. You can prevent the board from booting the OS if any of the power-up tests fail by

setting the NVRAM configuration parameter HaltOnFailure (see

Tab le 8 -1 and page 8-13).

Hardware

initialization

and power-up

diagnostic

reports

Monitor

command

prompt

Hello World !!!!!!!!!!!!!

MPC860 and SMC are initialized

Memory Size is 0x00400000

860 Decrementer Test PASSED

860 Time Base Timer Test PASSED

Print Hex Test, should = 89ABCDEF ? 89ABCDEF

Power Up Memory Test

Memory Test at 0x00040000 PASSED

Address Boundary Clear PASSED

All Memory Address Test ********

PASSED

BSS Zeroed

Data Section Relocated

Exception Vector Table Set to 0x0

Stack has been initialized to 0x10000 - 8

Monitor Cold Started

Power Up EEPROM Test PASSED

MPC860 Power Up Cache Test PASSED

PCI Bus Interface Initialized

Created: Thu Jan 11 13:04:24 2001

===========

=== ===

=== === ======

=========== ==

=========== === === == ==

=== ==== ==== == ===

=== ========== == ==

=== == == == == ==

=== == == == ==

PM/T1[Rev 2.6]

PM/Link (TM) Debug Monitor

Artesyn Communication Products,Inc.

Version Rev 2.6