Installation Instructions

Section 5876 Installation Instructions
Issue AT, April 26, 2013 Spec. No. 582140000 (Models 802
NLDB, 802NLEB and 802NL-B)
Page 5-10 Chapter 5. Installing the Rectifiers and Initially Starting the System
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
TASK KEY OR KEY COMBINATIONS NOTES
Getting to Home Position
YES / + / i and NO / -
At any level in the MCA menus,
pressing YES / + / i and NO / -
simultaneously takes you back to the
beginning of the MCA menu tree.
Moving from One Menu
to Another Menu
ENTER
You can travel left to right from one
menu to another by pressing ENTER.
You can also go back to a specified
menu by pressing ENTER while the
menu's name is being displayed.
Moving Within a Menu
UP ARROW, DOWN ARROW
Press UP ARROW to move up the list
of available entries in the active menu.
Press DOWN ARROW to move down
the list of available entries in the active
menu.
Entering the
Adjustment/Change
Setting Mode
Changing a Value or Setting
Changing the
Value or Setting
Locking the Change
Confirming the Change
ENTER and ALARM CUTOFF
YES / + / i and NO / -
ENTER
YES / + / i and NO / -
Changing a value or setting requires
four (4) steps.
1. With the current value or setting
being displayed, simultaneously
press ENTER and ALARM
CUTOFF.
2. To increase the value or change
the setting, press YES / + / i. To
decrease the value or change the
setting, press NO / -.
3. With the correct value or setting
being displayed, press ENTER.
4. To accept the change, at the
"ARE YOU SURE?" prompt press
YES / + / i. To reject the change,
at the "ARE YOU SURE?" prompt
press NO / -.
Changing a Control Function
Entering the
Adjustment/Change
Setting Mode
Confirming the Change
ENTER and ALARM CUTOFF
YES / + / i and NO / -
Changing a control function requires
two (2) steps.
1. With the control function menu
item being displayed,
simultaneously press ENTER and
ALARM CUTOFF.
2. To accept the change, at the
"ARE YOU SURE?" prompt press
the
YES / + / i. To reject the
change, at the "ARE YOU
SURE?" prompt press NO / -.
YES / + / i
NO / -
ENTER / /
Up
Down
FUNCTION
SELECT
ALARM
CUTOFF
ENTER / /
YES / + / i
NO / -
ENTER / /
YES / + / i
NO / -
ALARM
CUTOFF
ENTER / /
YES / + / i
NO / -