Installation Instructions

Installation Instructions Section 5876
Spec. No. 582140000 (Models 802
NLDB, 802NLEB and 802NL-B) Issue AT, April 26, 2013
Chapter 3. Installing Distribution Devices and MCA/LMS Circuit Cards Page 3-19
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
6) When all circuit cards have been installed, slide the circuit card retaining angle
up and secure by tightening the two screws.
7) When all circuit cards have been installed, remove the grounding wrist strap.
8) After all electrical connections are made, close the bay's front door.
9) Save several of the static protective bags that the circuit cards were shipped in.
If a circuit card is ever required to be removed from the system, it should
immediately be placed in a static protective bag.