Application Guide

Section 5876 Installation Instructions
Issue AT, April 26, 2013 Spec. No. 582140000 (Models 802
NLDB, 802NLEB and 802NL-B)
Page 2-34 Chapter 2. Placing the Bays and Installing Internal/External Busbars
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
INSTALLING OPTIONAL POWER/DISTRIBUTION BAY BUSBAR
SHIELD KIT, P/N 528482 (IF FURNISHED)
Tools and Material Required to Install the Busbar Assembly
a) 9/16" Wrench (for 3/8" Hardware)
b) Torque Wrench
Installation Procedure
Danger: Before performing this procedure, ensure that the Power/Distribution Bay
is COMPLETELY DISCONNECTED from all power sources.
Assemble the "Busbar Shield Kit, P/N 528482" to each "External Top-Mount Horizontal
Battery Input Busbar Assembly, P/N 554873" as shown in Figure 2-22.
Figure 2-22
Optional Power/Distribution Bay Busbar Shield Kit (P/N 528482)
P/N 554873
Busbar Assembly
Torque to 143 in-lbs.
3/8-16 x 5/8" Bolt, P/N 227646500 (one per side)
3/8" Lock Washer, P/N 215111300 (one per side)
3/8" Flat Washer, P/N 214112100 (one per side)
(support bar)
Insulator, P/N 245857100 (one per side)
Busbar Shield, P/N 528481
Note: Place Flap on Shield over Support Bar
(see assembled views)
3/8" Flat Washer, P/N 214112100 (one per side)
3/8" Lock Washer, P/N 215111300 (one per side)
3/8-16 x 7/8" Bolt, P/N 227646700 (one per side)
Torque to 143 in-lbs.
P/N 528482
Busbar
Shield
Kit
Assembled
Views
P/N 528482
Shield Kit
P/N 554873
Busbar
Assembly
Support Bar
Shield Lip