Application Guide

Section 5876 Installation Instructions
Issue AT, April 26, 2013 Spec. No. 582140000 (Models 802
NLDB, 802NLEB and 802NL-B)
Page 5-8 Chapter 5. Installing the Rectifiers and Initially Starting the System
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Figure 5-2
MCA Local Control Panel and Display
Alarm
Cutoff
Indicator
(Yellow)
FUNCTION SET
YES / + / i
Pushbutton Switch
ENTER / /
Pushbutton Switch
NO / -
Pushbutton Switch
ALARM
CUTOFF
Pushbutton
Switch
FUNCTION
SELECT
Up / Down
Pushbutton
Switches
TESTEQ
Indicator
(Yellow)
AC
Indicator
(Green - OK
Red - Fail)
MINOR
Indicator
(Red)
MAJOR
Indicator
(Flashes
Red)
Audible
Alarm
FRONT DOOR
(PRIMARY POWER/DISTRIBUTION AND POWER ONLY BAYS)
MCA CONTROL PANEL AND DISPLAY
LMS LOCAL PORT
(USB)
(active only if
optional LMS installed)
(Provided via a USB Type B to RS-232 Port Adapter Unit)
15
9 6
Mating Connector
in Power System Wire Harness
(9-Pin Female D-Type Jack)
If required to connect to a serial
port, disconnect the factory plug to
the “USB to RS-232 Port Adapter
Unit” and connect to this plug.