Application Guide

Installation Instructions Section 5876
Spec. No. 582140000 (Models 802
NLDB, 802NLEB and 802NL-B) Issue AT, April 26, 2013
Chapter 5. Installing the Rectifiers and Initially Starting the System Page 5-7
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
INITIALLY STARTING, CONFIGURING,
AND CHECKING SYSTEM OPERATION
Observe the Following Admonishment
Caution: Performing various steps in the following procedures may cause a
service interruption and/or result in the extension of alarms. Notify any
appropriate personnel before starting this procedure. Also notify this
personnel when this procedure is completed.
MCA (Meter, Control, Alarm Panel)
MCA Local Control Panel and Display
In the following procedures, all controls and indicators are located on the MCA Local
Control Panel, unless otherwise indicated. The MCA Local Control Panel is located on
the front of the Primary Power/Distribution or Power Only Bay. See Figure 5-2
.