Ordering Guides

System Application Guide SAG582136600
Spec. No. 582136600 (Model 211
NGFB) Issue AU, February 21, 2014
Page 21 of 105
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
List 89: Relay Rack Earthquake Anchor Kit, P/N P0987167
Features
♦ Provides four (4) sets of hardware for anchoring the relay rack to the floor.
Ordering Notes
1) Order as required.
List 90: Optional Temperature Probe,
P/N 04118246 (shelf side half) and P/N 04118247 (probe side half, 9 ft. long)
Features
♦ Up to two (2) temperature probes can be connected to the Customer Interface (IB2) Board. Either or both
probes can be programmed to monitor
ambient temperature or battery
temperature.
♦ A temperature probe set as a battery
probe can also be designated to be used for the battery charge temperature compensation feature. If the
system is equipped with the ACU+ Controller, the battery charge temperature compensation feature can
be programmed to use one probe or the average or highest value of all probes programmed to monitor
battery temperature. The battery charge temperature compensation feature allows the controller to
automatically increase or decrease the output voltage of the system to maintain battery float current as
battery temperature decreases or increases, respectively. Battery life can be extended when an optimum
charge voltage to the battery with respect to temperature is maintained.
♦ If the system is equipped with the ACU+ Controller, a temperature probe set as a battery probe can also
be used for controlling against battery thermal runaway (BTRM feature).
♦ The Temperature Probe assembly consists of two pieces that plug together to make a complete probe.
When ordered, P/N 04118246 (3 feet long) is pre-wired to the shelf and P/N 04118247 (9 feet long) is
shipped loose. Total length: 12 ft.
Restrictions
A temperature probe programmed to monitor battery temperature should be mounted on the top or side of a
battery cell to sense battery temperature. A temperature probe used for battery charge temperature
compensation or BTRM (Battery Thermal Runaway Management) should also be mounted on the top or side
of a battery cell. A temperature probe programmed to monitor ambient temperature should be mounted in a
convenient location, away from direct sources of heat or cold.
Ordering Notes
1) Order up to two (2) Temperature Probes for each shelf, as required.
Each List 90 includes one (1) P/N 04118246 and one (1) P/N 04118247.
2) For a Temperature Probe with a longer cable see List 91.
List 91: Optional Temperature Probe,
P/N 04118246 (shelf side half) and P/N 04116740 (probe side half, 30 ft. long)
Features
♦ See above for description of Temperature Probes.
♦ The Temperature Probe assembly consists of two pieces that plug together to make a complete probe.
When ordered, P/N 04118246 (3 feet long) is pre-wired to the shelf and P/N 04116740 (30 feet long) is
shipped loose. Total Length: 33 ft.
Restrictions
See above for restrictions.
Ordering Notes
1) Order up to two (2) Temperature Probes for each shelf, as required.
Each List 91 includes one (1) P/N 04118246 and one (1) P/N 04116740.
Home