Installation Manual

Emerson Network Power
Buried Distribution Products
631-200-108
Version B, March 18, 2013
Page 6 of 14 Proprietary Information Outside Plant Equipment
3.2 Mounting the Enclosure on a Pad
Note: To ease installation, the doors of the enclosure can be removed, as well as either
of the lower covers.
3.2.1 You Will Need - To mount the enclosure on a pad, you will need to supply:
•four
1
/
2
-13 threaded anchors and
•a
3
/
4
" hex socket wrench.
3.2.2 Procedure - Perform the following steps to mount the enclosure on a pad:
Step 1: Unpack the enclosure and dispose of the packing materials properly.
Step 2: Install
1
/
2
-13 threaded anchors in the pad at the locations shown in Fig. 7. Center
the mounting holes around the pad’s cable opening or according to local practices.
(The slots on the bottom of the enclosure for the pad mounting hardware are shown
in Fig. 8)
Pad
Outside of the Enclosure
17.0
(432mm)
Reference
Cable Opening in Pad
1.0
(25.4mm)
15.0
21.0
(533mm)
43.2
(1097mm)
Reference
11.1
(282mm)
1.0
(25.4mm)
11.1
(282mm)
Fig. 7 : Pad Mounting Hole Centers