User`s guide

Page 7

Controlinc 1746-C (Version 5.21) Network Master Users Guide (2004-11-18)

2. 1746-C Hardware

2.1. Hardware Setup

Refer to Chapter 1 of the 1746-BAS manual. The following hardware jumper settings are required. If the

1746-BAS module was supplied by EIM, jumpers are already set and no other settings are required.

For the 1746-C to run, the jumper

settings should be set as follows:

• JW1 - enable RS232

• JW2 - enable RS232

• JW3 - M2 EEPROM

• JW4 - PRT1 = ASCII

- PRT2 = ASCII

- DH485 = PGM

This jumper configuration is

normally performed by EIM before

shipping the 1746-C.

JW2

JW1

JW4

JW3

JW2

JW3

JW4

JW1