Technical data

Pin Assignments
MVME6100 Single Board Computer Installation and Use (6806800D58E)
98
5.3.3 PMC/IPMC Selection Headers (J10, J15 — J18, J25 — J28)
Nine 3-pin 2 mm planar headers allow for PMC/IPMC I/O selection. These nine headers can also
be combined into one single header block where a block shunt can be used as a jumper. The pin
assignments for these connectors are as follows:
A jumper installed across pins 2 and 3 on all nine headers selects PMC1 I/O for IPMC mode.
5.3.4 COM2 Header (J29)
A 10-pin 0.100" planar header provides the interface to a second asynchronous serial debug
port. COM2 only goes to the on-board header as the default configuration. The pin
assignments for this header are as follows:
Table 5-18 PMC/IPMC Configuration Jumper Block
Pin/Row 1
(PMC I/O)
Pin/Row 2
(P2 Pins)
Pin/Row 3
(IPMC Pins)
J28 PMC1_IO(2) P2_PMC1_IO(2) IPMC DB8_L
J16 PMC1_IO(5) P2_PMC1_IO(5) IPMC DB9_L
J18 PMC1_IO(8) P2_PMC1_IO(8) IPMC DB10_L
J25 PMC1_IO(11) P2_PMC1_IO(11) IPMC DB11_L
J27 PMC1_IO(14) P2_PMC1_IO(14) IPMC DB12_L
J26 PMC1_IO(17) P2_PMC1_IO(17) IPMC DB13_L
J17 PMC1_IO(20) P2_PMC1_IO(20) IPMC DB14_L
J10 PMC1_IO(23) P2_PMC1_IO(23) IPMC DB15_L
J15 PMC1_IO(26) P2_PMC1_IO(26) IPMC DBP1_L
Table 5-19 COM2 Planar Serial Port Header (J29) Pin Assignments
Pin Signal Signal Pin
1 COM2_DCD COM2_DSR 2
3 COM2_RX COM2_RTS 4
5 COM2_TX COM2_CTS 6