Technical data

Connectors and Cables General Information
MVME7616E Transition Module Installation and Use (6806800A43B)
17
Parallel port J4 36-pin female parallel port connector
10Base-T,
100Base-TX
J9 8-pin female RJ-45 Ethernet port connector
SIM J1, J12 60-pin female connector
VME P2 64-pin male connector to J2 on the P2 adapter
Table 1-3 3-Row P2 Adapter Connectors (MVME761-001)
Type Number Description
VME P1 96-pin female DIN 41612 connector to the chassis backplane
J3 64-pin male connector for output to P2 on the MVME761 transition module
SCSI J2 50-pin male IDC connector for internal SCSI devices
Table 1-4 5-Row P2 Adapter Connectors (MVME761-011)
Type Number Description
VME P1 160-pin female DIN 41612 connector to the chassis backplane
J4 64-pin male connector for output to P2 on the MVME761 transition
module
PMC I/O J3 64-pin male connector for PMC I/O
SCSI J1 68-pin female IDC connector for internal SCSI devices
Table 1-5 Transition Module Cables
Part Number Description
Included with the
MVME761-0x1
64-line flat ribbon cable with 96-pin DIN connectors that connects P2 on
the MVME761transition module to J3 on the 3-row P2 Adapter or J4 on
the 5-row P2 adapter; 13 inches long. (30-W2799B02A).
User-supplied EIA-232-D DTE or DCE cable (pins used depend on the processor
VMEmodule)
User-supplied Centronics- type parallel printer cable, male-to-male
User-supplied 20-conductor cable; usually supplied with the modem
User-supplied 6-conductor cable; usually supplied with the modem
CBL761HD26DB25 Straight-through adapter cable with male HD-26 connector and female
DB-25 connector, 3 feet long. (30-NW9302B27)
If you supply your own 64-line cable to connect the P2 adapter to the MVME761 transition module, the
cable should not be longer than 1.5 feet. A longer cable is likely to cause problems, especially for the
Ethernet and parallel port signals.
Table 1-2 MVME761 Transition Module Connectors (continued)
Type Number Description