Manualshelf

Technical data

ManualsBrandsEmerson ManualsComputer equipmentMVME51005E
21222324252627282930
PMCspan PMC Carrier Module Installation and Use (6806800A59B)
2 Hardware Installation
12
5. Attach the four standoffs from the secondary PMCspan mounting kit to the primary
PMCspan by screwing the threaded male portion of the standoffs in the locations where
the screws were removed in the previous step.
6. Place the secondary PMCspan on top of the primary PMCspan. Align the mounting
holes in each corner to the standoffs and align the secondary PMCspan connector P3
with primary PMCspan connector J3.
7. Gently press the two PMCspan modules together and verify that P3 is fully seated in
J3.
8. Insert the four screws (Phillips type) through the holes at the corners of the secondary
PMCspan and into the standoffs on the primary PMCspan. Tighten screws securely.
Note
The screws have two different head diameters. Use the screws with the
smaller heads on the standoffs next to VMEbus connectors P1 and P2.