Technical data

MVME51005E Single Board Computer Installation and Use (6806800A38B)
6Pin Assignments
54
Connectors
IPMC761 Connector (J3) Pin Assignments
This connetor is used to provide an interface to the IPMC761 module signals and is located near
J11. The pin assignments for this connector are as follows:
J4 Ethernet Port 2 Selection
(set in conjunction with
jumpers J10 and J17)
For “P2” Ethernet Port 2:
Pins 1,2; 3,4; 5,6; 7,8 (set for
712/761)
No
Jumper
Installed
(front
panel)
For “Front Panel” Ethernet Port 2:
No Jumpers Installed
J6, J20 Operation Mode
(Set Both Jumpers)
Pins 1,2 for PMC Mode PMC
Mode
Pins 2,3 for SBC Mode (761 Mode)
J7 Flash Memory Selection
at Boot
Pins 1,2 for Soldered Bank A Socketed
Bank B
Pins 2,3 for Socketed Bank B
J10, J17 Ethernet Port 2 Selection
(set in conjunction with jumper
J4)
For “Front Panel” Ethernet Port 2:
Pins 1,3 and 2,4 on Both Jumpers
Front
Panel
Ethernet
Port 2
For “P2” Ethernet Port 2:
Pins 3,5 and 4,6 on Both Jumpers
(set for 712/761)
J15 System Controller (VME) Pins 1,2 for No SCON
Auto
SCON
Pins 2,3 for Auto SCON
No Jumper for ALWAYS SCON
J16 Soldered Flash Protection Pins 1,2 Enables Programming of
Flash
Flash
Prog.
Enabled
Pins 2,3 Disables Programming of
the upper 64KB of Flash
Jumper Description Setting Default
Table 6-1. IPMC761 Connector Pin Assignments
Pin Assignment Pin
1 I2CSCL I2CSDA 2
3GND GND 4
5DB8# GND 6
7GND DB9# 8
9DB10# +3.3V 10
11 +3.3V DB11# 12
13 DB12# GND 14
15 GND DB13# 16
17 DB14# +3.3V 18