Technical data

MVME51005E Single Board Computer Installation and Use (6806800A38B)
3 PPCBug Firmware
26
Network Auto Boot at power-up only [Y/N] = N?
Network Auto Boot Controller LUN = 00?
Refer to the PPCBug Firmware Package User's Manual, listed in Appendix D, Related
Documentation for a listing of network controller modules currently supported by PPCBug.
(Default = 0x00)
Network Auto Boot Device LUN = 00?
Refer to the PPCBug Firmware Package User's Manual, listed in Appendix D, Related
Documentation for a listing of network controller modules currently supported by PPCBug.
(Default = 0x00)
Network Auto Boot Abort Delay = 5?
The time in seconds that the NETboot sequence will delay before starting the boot. The
purpose for the delay is to allow you the option of stopping the boot by use of the
BREAK key.
The time value is from 0-255 seconds. (Default = 5 seconds)
Network Auto Boot Configuration Parameters Offset (NVRAM) = 00001000?
The address where the network interface configuration parameters are to be saved/retained in
NVRAM; these parameters are the necessary parameters to perform an unattended network
boot. A typical offset might be 0x1000, but this value is application-specific. (Default =
0x00001000)
!
Caution
If you use the NIOT debugger command, these parameters need to be saved
somewhere in the offset range 0x00001000 through 0x000016F7. The NIOT
parameters do not exceed 128 bytes in size. The setting of this ENV pointer
determines their location. If you have used the same space for your own
program information or commands, they will be overwritten and lost.
You can relocate the network interface configuration parameters in this space
by using the ENV command to change the Network Auto Boot Configuration
Parameters Offset from its default of 0x00001000 to the value you need to be
clear of your data within NVRAM.
Memory Size Enable [Y/N] = Y?
Memory Size Starting Address = 00000000?
The default Starting Address is 0x00000000.
Y NETboot is attempted at powerup reset only.
N NETboot is attempted at any reset. (Default)
Y Memory will be sized for SelfTest diagnostics.
(Default)
N Memory will not be sized for SelfTest diagnostics.