Technical data

3 PPCBug Firmware

MVME51005E Single Board Computer Installation and Use (6806800A38B)

Network PReP-Boot Mode Enable [Y/N] = N?

Negate VMEbus SYSFAIL* Always [Y/N] = N?

SCSI Bus Reset on Debugger Startup [Y/N] = N?

Primary SCSI Bus Negotiations Type [A/S/N] = A?

Primary SCSI Data Bus Width [W/N] = N?

Secondary SCSI identifier = 07?

Select the identifier. (Default = 07.)

NVRAM Bootlist (GEV.fw-boot-path) Boot Enable [Y/N] = N?

Note

When enabled, the GEV boot takes priority over all other boots, including Autoboot and

Network Boot.

Y Enable PReP-style network booting (same boot

image from a network interface as from a mass

storage device).

N Do not enable PReP-style network booting.

(Default)

Y Negate the VMEbus SYSFAIL

∗ signal during

board initialization.

N Negate the VMEbus SYSFAIL

∗ signal after

successful completion or entrance into the bug

command monitor. (Default)

Y Local SCSI bus is reset on debugger setup.

N Local SCSI bus is not reset on debugger setup.

(Default)

A Asynchronous SCSI bus negotiation. (Default)

S Synchronous SCSI bus negotiation.

N None.

W Wide SCSI (16-bit bus).

N Narrow SCSI (8-bit bus). (Default)

Y Give boot priority to devices defined in the fw-

boot-path global environment variable (GEV).

N Do not give boot priority to devices listed in the

fw-boot-path GEV. (Default)